on a chroot daemon (it does not imply --numeric-ids).
dit(bf(-o, --owner)) This option causes rsync to set the owner of the
destination file to be the same as the source file. On most systems,
dit(bf(-o, --owner)) This option causes rsync to set the owner of the
destination file to be the same as the source file. On most systems,
-only the super-user can set file ownership. Note that if the remote system
-is a daemon using chroot, the --numeric-ids option is implied because the
-remote system cannot get access to the usernames from /etc/passwd.
+only the super-user can set file ownership. The preservation is done
+primarily by name, but falls back to using the ID number if the ID has
+no name on the sending side or has no match on the receiving side.
+See also the --numeric-ids option and the "use chroot" setting in the
+rsyncd.conf manpage.
dit(bf(-g, --group)) This option causes rsync to set the group of the
destination file to be the same as the source file. If the receiving
program is not running as the super-user, only groups that the
dit(bf(-g, --group)) This option causes rsync to set the group of the
destination file to be the same as the source file. If the receiving
program is not running as the super-user, only groups that the
-receiver is a member of will be preserved (by group name, not group ID
-number).
+receiver is a member of will be preserved. The preservation is done
+primarily by name, but falls back to using the ID number if the ID has
+no name on the sending side or has no match on the receiving side.
+See also the --numeric-ids option and the "use chroot" setting in the
+rsyncd.conf manpage.
dit(bf(-D, --devices)) This option causes rsync to transfer character and
block device information to the remote system to recreate these
dit(bf(-D, --devices)) This option causes rsync to transfer character and
block device information to the remote system to recreate these
0 are never mapped via user/group names even if the --numeric-ids
option is not specified.
0 are never mapped via user/group names even if the --numeric-ids
option is not specified.
-If the source system is a daemon using chroot, or if a user or group
-name does not exist on the destination system, then the numeric ID
-from the source system is used instead.
+If a user or group has no name on the source system or it has no match
+on the destination system, then the numeric ID
+from the source system is used instead. See also the comments on the
+"use chroot" setting in the rsyncd.conf manpage.
dit(bf(--timeout=TIMEOUT)) This option allows you to set a maximum I/O
timeout in seconds. If no data is transferred for the specified time
dit(bf(--timeout=TIMEOUT)) This option allows you to set a maximum I/O
timeout in seconds. If no data is transferred for the specified time