Removing --csum-length option documentation since there is

no such option.

diff --git a/rsync.yo b/rsync.yo
index 43edd8f..bc3b713 100644 (file)
--- a/rsync.yo
+++ b/rsync.yo
@@ -654,25 +654,6 @@ Finally, any file is ignored if it is in the same directory as a
 .cvsignore file and matches one of the patterns listed therein.  See
 the bf(cvs(1)) manual for more information.
 
 .cvsignore file and matches one of the patterns listed therein.  See
 the bf(cvs(1)) manual for more information.
 

-dit(bf(--csum-length=LENGTH)) By default the primary checksum used in
-rsync is a very strong 16 byte MD4 checksum. In most cases you will
-find that a truncated version of this checksum is quite efficient, and
-this will decrease the size of the checksum data sent over the connection,
-making things faster. 
-
-You can choose the number of bytes in the truncated checksum using the
---csum-length option. Any value less than or equal to 16 is valid.
-
-Note that if you use this option then you run the risk of ending up
-with an incorrect target file. The risk with a value of 16 is
-microscopic and can be safely ignored (the universe will probably end
-before it fails) but with smaller values the risk is higher.
-
-Current versions of rsync actually use an adaptive algorithm for the
-checksum length by default, using a 16 byte file checksum to determine
-if a 2nd pass is required with a longer block checksum. Only use this
-option if you have read the source code and know what you are doing.
-

 dit(bf(-T, --temp-dir=DIR)) This option instructs rsync to use DIR as a
 scratch directory when creating temporary copies of the files
 transferred on the receiving side.  The default behavior is to create
 dit(bf(-T, --temp-dir=DIR)) This option instructs rsync to use DIR as a
 scratch directory when creating temporary copies of the files
 transferred on the receiving side.  The default behavior is to create