--files-from=FILE read list of source-file names from FILE
-0, --from0 all *from file lists are delimited by nulls
--version print version number
+ --address=ADDRESS bind address for outgoing socket to daemon
--port=PORT specify double-colon alternate port number
--blocking-io use blocking I/O for the remote shell
--no-blocking-io turn off blocking I/O when it is default
--list-only list the files instead of copying them
--bwlimit=KBPS limit I/O bandwidth; KBytes per second
--write-batch=FILE write a batched update to FILE
+ --only-write-batch=FILE like --write-batch but w/o updating dest
--read-batch=FILE read a batched update from FILE
--protocol=NUM force an older protocol version to be used
--checksum-seed=NUM set block/file checksum seed (advanced)
timeout in seconds. If no data is transferred for the specified time
then rsync will exit. The default is 0, which means no timeout.
+dit(bf(--address)) By default rsync will bind to the wildcard address when
+connecting to an rsync daemon. The bf(--address) option allows you to
+specify a specific IP address (or hostname) to bind to. See also this
+option in the bf(--daemon) mode section.
+
dit(bf(--port=PORT)) This specifies an alternate TCP port number to use
rather than the default of 873. This is only needed if you are using the
double-colon (::) syntax to connect with an rsync daemon (since the URL
dit(bf(--write-batch=FILE)) Record a file that can later be applied to
another identical destination with bf(--read-batch). See the "BATCH MODE"
-section for details.
+section for details, and also the bf(--only-write-batch) option.
+
+dit(bf(--only-write-batch=FILE)) Works like bf(--write-batch), except that
+no updates are made on the destination system when creating the batch.
+This lets you transport the changes to the destination system via some
+other means and then apply the changes via bf(--read-batch).
+
+Note that you can feel free to write the batch directly to some portable
+media: if this media fills to capacity before the end of the transfer, you
+can just apply that partial transfer to the destination and repeat the
+whole process to get the rest of the changes (as long as you don't mind a
+partially updated destination system while the multi-update cycle is
+happening).
+
+Also note that you only save bandwidth when pushing changes to a remote
+system because this allows the batched data to be diverted from the sender
+into the batch file without having to flow over the wire to the receiver
+(when pulling, the sender is remote, and thus can't write the batch).
dit(bf(--read-batch=FILE)) Apply all of the changes stored in FILE, a
file previously generated by bf(--write-batch).
requests accordingly. See the rsyncd.conf(5) man page for more
details.
-dit(bf(--address)) By default rsync will bind to the wildcard address
-when run as a daemon with the bf(--daemon) option or when connecting to a
-rsync server. The bf(--address) option allows you to specify a specific IP
-address (or hostname) to bind to. This makes virtual hosting possible
-in conjunction with the bf(--config) option. See also the "address" global
-option in the rsyncd.conf manpage.
+dit(bf(--address)) By default rsync will bind to the wildcard address when
+run as a daemon with the bf(--daemon) option. The bf(--address) option
+allows you to specify a specific IP address (or hostname) to bind to. This
+makes virtual hosting possible in conjunction with the bf(--config) option.
+See also the "address" global option in the rsyncd.conf manpage.
dit(bf(--bwlimit=KBPS)) This option allows you to specify a maximum
transfer rate in kilobytes per second for the data the daemon sends.
Matt McCutchen's Web Site / rsync / rsync.git / blobdiff