- - Added the --partial-dir=DIR option that lets you specify where to
- (temporarily) put a partially transferred file (instead of over-
- writing the destination file). E.g. --partial-dir=.rsync-partial
- Also added support for the RSYNC_PARTIAL_DIR environment variable
- that, when found, transforms a regular --partial option (such as
- the convenient -P option) into one that also specifies a directory.
-
- - Added --keep-dirlinks (-K), which allows you to symlink a directory
- onto another partition on the receiving side and have rsync treat it
- as matching a normal directory from the sender.
-
- - Added the --inplace option that tells rsync to write each destination
- file without using a temporary file. The matching of existing data
- in the destination file can be severely limited by this, but there
- are also cases where this is more efficient (such as appending data).
- Use only when needed (see the man page for more details).
-
- - Added the "write only" option for the daemon's config file.
-
- - Added long-option names for -4 and -6 (namely --ipv4 and --ipv6)
- and documented all these options in the man page.
-
- - Improved the handling of the --bwlimit option so that it's less
- bursty, more accurate, and works properly over a larger range of
- values.
-
- - The rsync daemon-over-ssh code now looks for SSH_CONNECTION and
- SSH2_CLIENT in addition to SSH_CLIENT to figure out the IP address.
+ - Added the --only-write-batch=FILE option that may be used (instead
+ of --write-batch=FILE) to create a batch file without doing any
+ actual updating of the destination. This allows you to divert all
+ the file-updating data away from a slow data link (as long as you
+ are pushing the data to the remote server when creating the batch).