-NEWS for rsync version 2.6.0
-Protocol: 27 (changed)
-Changes since version 2.5.7:
-
- ENHANCEMENTS:
-
- * Added --files-from, --no-relative, --no-implied-dirs, and --from0.
- Note that --from0 affects the line-ending character for all the
- files read by the --*-from options. (Wayne Davison)
-
- * Length of csum2 is now per-file starting with protocol verison
- 27. (J.W. Schultz)
-
- * Per-file dynamic block size is now sqrt(file length).
- The per-file checksum size is determined according
- to an algorythm provided by Donovan Baarda which
- reduces the probability of rsync algorithm
- corrupting data and falling back using the whole md4
- checksums. (J.W. Schultz, Donovan Baarda)
-
- * The --stats option no longer includes the (debug) malloc summary
- unless the verbose option was specified at least twice.
-
- * Added a new error/warning code for when files vanish from the
- sending side. Made vanished source files not interfere with the
- file-deletion pass when --delete-after was specified.
+NEWS for rsync 2.6.5 (UNRELEASED)
+Protocol: 29 (unchanged)
+Changes since 2.6.4:
+
+ OUTPUT CHANGES:
+
+ - Non-printable chars in filenames are now output using backslash-
+ escaped characters rather than '?'s. Any non-printable character is
+ output using 3 digits of octal (e.g. "\n" -> "\012"), and a backslash
+ is now output as "\\". Rsync also uses your locale setting, which
+ can make it treat fewer high-bit characters as non-printable.
+
+ - If rsync received an empty file list when pulling files, it would
+ output a "nothing to do" message and exit with a 0 (success) exit
+ status, even if the remote rsync returned an error (it did not do
+ this under the same conditions when pushing files). This was changed
+ to make the pulling behavior the same as the pushing behavior: we
+ now do the normal end-of-run outputting (depending on options) and
+ exit with the appropriate exit status.