Refer to the rsync daemon as a "daemon", not a "server". This is

[rsync/rsync.git] / NEWS

diff --git a/NEWS b/NEWS
index 7e60add..c18a7d8 100644 (file)
--- a/NEWS
+++ b/NEWS
@@ -2,6 +2,23 @@ NEWS for rsync 2.6.5 (UNRELEASED)
 Protocol: 29 (unchanged)
 Changes since 2.6.4:
 
+  OUTPUT CHANGES:
+
+    - Non-printable chars in filenames are now output using backslash-
+      escaped characters rather than '?'s.  Any non-printable character is
+      output using 3 digits of octal (e.g. "\n" -> "\012"), and a backslash
+      is now output as "\\".  Rsync also uses your locale setting, which
+      should make it treat fewer high-bit characters as non-printable (when
+      appropriate).
+
+    - If rsync received an empty file list when pulling files, it would
+      output an "nothing to do" message and exit with a 0 (success) exit
+      status, even if the remote rsync returned an error (it did not do
+      this under the same conditions when pushing files).  This was changed
+      to make the pulling behavior the same as the pushing behavior -- we
+      now do the normal end-of-run outputting (depending on options) and
+      exit with the appropriate exit status.
+
   BUG FIXES:
 
     - A crash bug was fixed when a daemon had its "path" set to "/", did
@@ -9,7 +26,7 @@ Changes since 2.6.4:
       rsyncd.conf file.
 
     - Fixed a bug in the transfer of a single file when -H is specified
-      that might have caused an infininte loop or perhaps a crash.
+      that might have caused an infinite loop or perhaps a crash.
 
     - Fixed a case where the generator might try to tweak the write
       permissions of a read-only directory in list-only mode.
@@ -42,6 +59,13 @@ Changes since 2.6.4:
       to a file in a --link-dest dir doesn't link the files from the rest
       of the cluster.
 
+    - When deleting files with the --one-file-system (-x) option set, rsync
+      no longer tries to remove files from inside a mount-point on the
+      receiving side.
+
+    - Fixed a compatibility problem when using --cvs-ignore (-C) and
+      sending files to an older rsync without using --delete.
+
   ENHANCEMENTS:
 
     - Added the --only-write-batch=FILE option that may be used (instead
@@ -50,9 +74,10 @@ Changes since 2.6.4:
       the file-updating data away from a slow data link (as long as you
       are pushing the data to the remote server when creating the batch).
 
-    - Changed the outputting of "safe" filenames to use backslash-escaped
-      characters rather than '?'s.  Any non-printable character is output
-      using octal (e.g. "\n" -> "\012"), and backslash is output as "\\".
+    - When the generator is taking a long time to fill up its output buffer
+      (e.g. if the transferred files are few, small, or missing), it now
+      periodically flushes the output buffer so that the sender/receiver
+      can get started on the files sooner rather than later.
 
     - Improved the auth-errors that are logged by the daemon to include
       some information on why the authorization failed (wrong user,