tt(rsync -av /src/foo/ /dest/foo)nl()
)
+Note also that host and module references don't require a trailing slash to
+copy the contents of the default directory. For example, both of these
+copy the remote directory's contents into "/dest":
+
+quote(
+tt(rsync -av host: /dest)nl()
+tt(rsync -av host::module /dest)nl()
+)
+
You can also use rsync in local-only mode, where both the source and
destination don't have a ':' in the name. In this case it behaves like
an improved copy command.
--list-only list the files instead of copying them
--bwlimit=KBPS limit I/O bandwidth; KBytes per second
--write-batch=FILE write a batched update to FILE
+ --only-write-batch=FILE like --write-batch but w/o updating dest
--read-batch=FILE read a batched update from FILE
--protocol=NUM force an older protocol version to be used
--checksum-seed=NUM set block/file checksum seed (advanced)
dit(bf(--write-batch=FILE)) Record a file that can later be applied to
another identical destination with bf(--read-batch). See the "BATCH MODE"
-section for details.
+section for details, and also the bf(--only-write-batch) option.
+
+dit(bf(--only-write-batch=FILE)) Works like bf(--write-batch), except that
+no updates are made on the destination system when creating the batch.
+This lets you transport the changes to the destination system via some
+other means and then apply the changes via bf(--read-batch).
+
+Note that you can feel free to write the batch directly to some portable
+media: if this media fills to capacity before the end of the transfer, you
+can just apply that partial transfer to the destination and repeat the
+whole process to get the rest of the changes (as long as you don't mind a
+partially updated destination system while the multi-update cycle is
+happening).
+
+Also note that you only save bandwidth when pushing changes to a remote
+system because this allows the batched data to be diverted from the sender
+into the batch file without having to flow over the wire to the receiver
+(when pulling, the sender is remote, and thus can't write the batch).
dit(bf(--read-batch=FILE)) Apply all of the changes stored in FILE, a
file previously generated by bf(--write-batch).