- - Fixed a crash bug that might appear when --delete was used and
- multiple source directories were specified.
-
- - Fixed the 32-bit truncation of the file length when generating the
- checksums.
-
- - The --backup code no longer attempts to create some directories
- over and over again (generating warnings along the way).
-
- - Fixed a bug in the reading of the secrets file (by the daemon) and
- the password file (by the client): the files no longer need to be
- terminated by a newline for their content to be read in.
-
- - If a file has a read error on the sending side or the reconstructed
- data doesn't match the expected checksum (perhaps due to the basis
- file changing during the transfer), the receiver will no longer
- retain the resulting file unless the --partial option was specified.
- (Note: for the read-error detection to work, neither side can be
- older than 2.6.3 -- older receivers will always retain the file, and
- older senders don't tell the receiver that the file had a read
- error.)
-
- - If a file gets resent in a single transfer and the --backup option
- is enabled, rsync no longer performs a duplicate backup (it used to
- overwrite the original file in the backup area).
-
- - Files specified in the daemon's "exclude" or "exclude from" config
- items are now excluded from being uploaded (assuming that the module
- allows uploading at all) in addition to the old download exclusion.
-
- - Got rid of a potential hang in the receiver when near the end of a
- phase.
-
- - When using --backup without a --backup-dir, rsync no longer preserves
- the modify time on directories. This avoids confusing NFS.
-
- - When --copy-links (-L) is specified, we now output a separate error
- for a symlink that has no referent instead of claiming that a file
- "vanished".
-
- - The --copy-links (-L) option no longer has the side-effect of telling
- the receiving side to follow symlinks. See the --keep-dirlinks
- option (mentioned below) for a way to specify that behavior.
-
- - Error messages from the daemon server's option-parsing (such as
- refused options) now get sent back to the client (the server used
- to just exit because the socket wasn't in the right state to send
- the message).
-
- - Most errors that occur during a daemon transfer are now returned to
- the user in addition to being logged (some messages are intended to
- be daemon-only).
-
- - Fixed a bug in the daemon authentication code when using one of the
- batch-processing options.
-
- - We try to work around some buggy IPv6 implementations that fail to
- implement IPV6_V6ONLY. This should fix the "address in use" error
- that some daemons get when running on an OS with a buggy IPv6
- implementation. Also, if the new code gets this error, we might
- suggest that the user specify --ipv4 or --ipv6 (if we think it will
- help).
-
- - When the remote rsync dies, make a better effort to recover any error
- messages it may have sent before dying (the local rsync used to just
- die with a socket-write error).
-
- - When using --delete and a --backup-dir that contains files that are
- hard-linked to their destination equivalents, rsync now makes sure
- that removed files really get removed (works around a really weird
- rename() behavior).
-
- - Avoid a bogus run-time complaint about a lack of 64-bit integers when
- the int64 type is defined as an off_t and it actually has 64-bits.
-
- - Added a configure check for open64() without mkstemp64() so that we
- can avoid using mkstemp() when such a combination is encountered.
- This bypasses a problem writing out large temp files on OSes such as
- AIX and HP-UX.
-
- - Fixed an age-old crash problem with --read-batch on a local copy
- (rsync was improperly assuming --whole-file for the local copy).
-
- - When --dry-run (-n) is used and the destination directory does not
- exist, rsync now produces a correct report of files that would be
- sent instead of dying with a chdir() error.
-
- - The "backed up ..." message that is output when at least 2 --verbose
- options are specified is now the same both with and without the
- --backup-dir option.
-
- - Fixed a bug that could cause a slow-to-connect rsync daemon to die
- with an error instead of waiting for the connection to finish.