Added more local-network IPs to the "hosts allow" rsyncd config

[rsync/rsync.git] / rsyncd.conf.yo

diff --git a/rsyncd.conf.yo b/rsyncd.conf.yo
index 5b7cc9b..6d4b2a4 100644 (file)
--- a/rsyncd.conf.yo
+++ b/rsyncd.conf.yo
@@ -226,6 +226,11 @@ file transfers to and from that module should take place as when the daemon
 was run as root. This complements the "uid" option. The default is gid -2,
 which is normally the group "nobody".
 
 was run as root. This complements the "uid" option. The default is gid -2,
 which is normally the group "nobody".
 

+dit(bf(fake super)) Setting "fake super = yes" for a module causes the
+daemon side to behave as if the bf(--fake-user) command-line option had
+been specified.  This allows the full attributes of a file to be stored
+without having to have the daemon actually running as root.
+

 dit(bf(filter)) The "filter" option allows you to specify a space-separated
 list of filter rules that the daemon will not allow to be read or written.
 This is only superficially equivalent to the client specifying these
 dit(bf(filter)) The "filter" option allows you to specify a space-separated
 list of filter rules that the daemon will not allow to be read or written.
 This is only superficially equivalent to the client specifying these


@@ -483,7 +488,10 @@ The "dont compress" option takes a space-separated list of
 case-insensitive wildcard patterns. Any source filename matching one
 of the patterns will not be compressed during transfer.
 
 case-insensitive wildcard patterns. Any source filename matching one
 of the patterns will not be compressed during transfer.
 

-The default setting is tt(*.gz *.tgz *.zip *.z *.rpm *.deb *.iso *.bz2 *.tbz)
+See the bf(--skip-compress) option in the bf(rsync)(1) manpage for the list
+of file suffixes that are not compressed by default.  Specifying a value
+for the bf(dont compress) option changes the default when the daemon is
+the sender.

 
 dit(bf(pre-xfer exec), bf(post-xfer exec)) You may specify a command to be run
 before and/or after the transfer.  If the bf(pre-xfer exec) command fails, the
 
 dit(bf(pre-xfer exec), bf(post-xfer exec)) You may specify a command to be run
 before and/or after the transfer.  If the bf(pre-xfer exec) command fails, the