Added get_xattr_acl(), set_xattr_acl(), and del_def_xattr_acl().

[rsync/rsync.git] / rsyncd.conf.yo

diff --git a/rsyncd.conf.yo b/rsyncd.conf.yo
index 5b7cc9b..cbd0dd9 100644 (file)
--- a/rsyncd.conf.yo
+++ b/rsyncd.conf.yo
@@ -161,7 +161,8 @@ sure).
 dit(bf(max connections)) The "max connections" option allows you to
 specify the maximum number of simultaneous connections you will allow.
 Any clients connecting when the maximum has been reached will receive a
-message telling them to try later.  The default is 0 which means no limit.
+message telling them to try later.  The default is 0, which means no limit.
+A negative value disables the module.
 See also the "lock file" option.
 
 dit(bf(log file)) When the "log file" option is set to a non-empty
@@ -226,6 +227,11 @@ file transfers to and from that module should take place as when the daemon
 was run as root. This complements the "uid" option. The default is gid -2,
 which is normally the group "nobody".
 
+dit(bf(fake super)) Setting "fake super = yes" for a module causes the
+daemon side to behave as if the bf(--fake-user) command-line option had
+been specified.  This allows the full attributes of a file to be stored
+without having to have the daemon actually running as root.
+
 dit(bf(filter)) The "filter" option allows you to specify a space-separated
 list of filter rules that the daemon will not allow to be read or written.
 This is only superficially equivalent to the client specifying these
@@ -483,7 +489,10 @@ The "dont compress" option takes a space-separated list of
 case-insensitive wildcard patterns. Any source filename matching one
 of the patterns will not be compressed during transfer.
 
-The default setting is tt(*.gz *.tgz *.zip *.z *.rpm *.deb *.iso *.bz2 *.tbz)
+See the bf(--skip-compress) option in the bf(rsync)(1) manpage for the list
+of file suffixes that are not compressed by default.  Specifying a value
+for the bf(dont compress) option changes the default when the daemon is
+the sender.
 
 dit(bf(pre-xfer exec), bf(post-xfer exec)) You may specify a command to be run
 before and/or after the transfer.  If the bf(pre-xfer exec) command fails, the