X-Git-Url: https://mattmccutchen.net/rsync/rsync.git/blobdiff_plain/3ae5367ff2241605ab8682063bb317708fc62e29..2a5d5a8cc4ad251d8d29e45e4be3d9c39228715b:/rsync.yo?ds=sidebyside

diff --git a/rsync.yo b/rsync.yo
index 9983ae4d..486ffae3 100644
--- a/rsync.yo
+++ b/rsync.yo
@@ -380,6 +380,7 @@ to the detailed description below for a complete description.  verb(
      --list-only             list the files instead of copying them
      --bwlimit=KBPS          limit I/O bandwidth; KBytes per second
      --write-batch=FILE      write a batched update to FILE
+     --only-write-batch=FILE like --write-batch but w/o updating dest
      --read-batch=FILE       read a batched update from FILE
      --protocol=NUM          force an older protocol version to be used
      --checksum-seed=NUM     set block/file checksum seed (advanced)
@@ -1275,7 +1276,24 @@ of zero specifies no limit.
 
 dit(bf(--write-batch=FILE)) Record a file that can later be applied to
 another identical destination with bf(--read-batch). See the "BATCH MODE"
-section for details.
+section for details, and also the bf(--only-write-batch) option.
+
+dit(bf(--only-write-batch=FILE)) Works like bf(--write-batch), except that
+no updates are made on the destination system when creating the batch.
+This lets you transport the changes to the destination system via some
+other means and then apply the changes via bf(--read-batch).
+
+Note that you can feel free to write the batch directly to some portable
+media: if this media fills to capacity before the end of the transfer, you
+can just apply that partial transfer to the destination and repeat the
+whole process to get the rest of the changes (as long as you don't mind a
+partially updated destination system while the multi-update cycle is
+happening).
+
+Also note that you only save bandwidth when pushing changes to a remote
+system because this allows the batched data to be diverted from the sender
+into the batch file without having to flow over the wire to the receiver
+(when pulling, the sender is remote, and thus can't write the batch).
 
 dit(bf(--read-batch=FILE)) Apply all of the changes stored in FILE, a
 file previously generated by bf(--write-batch).