X-Git-Url: https://mattmccutchen.net/rsync/rsync.git/blobdiff_plain/3a4c683f0445965c5800a81e3a54eedf17f2f319..a24e12e6dd814f7da77d121fcedf862f05f061f5:/Makefile.in

diff --git a/Makefile.in b/Makefile.in
index f2b8c1a1..71b3fa11 100644
--- a/Makefile.in
+++ b/Makefile.in
@@ -31,6 +31,11 @@ popt_OBJS=popt/findme.o  popt/popt.o  popt/poptconfig.o \
 	popt/popthelp.o popt/poptparse.o
 OBJS=$(OBJS1) $(OBJS2) $(DAEMON_OBJ) $(LIBOBJ) $(ZLIBOBJ) @BUILD_POPT@
 
+tls_OBJ = tls.o syscall.o 
+
+# Programs we must have to run the test cases
+CHECK_PROGS = rsync tls
+
 # note that the -I. is needed to handle config.h when using VPATH
 .c.o:
 @OBJ_SAVE@
@@ -55,6 +60,9 @@ install-strip:
 rsync: $(OBJS)
 	$(CC) $(CFLAGS) $(LDFLAGS) -o rsync $(OBJS) $(LIBS)
 
+tls: $(tls_OBJ)
+	$(CC) $(CFLAGS) $(LDFLAGS) -o $@ $(tls_OBJ) $(LIBS)
+
 Makefile: Makefile.in configure config.status
 	echo "WARNING: You need to run ./config.status --recheck"
 
@@ -73,6 +81,7 @@ proto:
 
 clean:
 	rm -f *~ $(OBJS) rsync 
+	rm -rf ./testtmp
 
 distclean: clean
 	rm -f config.h config.cache config.status Makefile
@@ -95,19 +104,23 @@ test: check
 # There seems to be no standard way to specify some variables as
 # exported from a Makefile apart from listing them like this.
 
-# TODO: These targets both ought to depend on a set of test programs
-# to build, if any.
+# TODO: Tests that depend on built test aide programs like tls need to
+# know where the build directory is.
 
 # This depends on building rsync; if we need any helper programs it
 # should depend on them too.
 
-check: all
-	rsync_bin=./rsync srcdir="$(srcdir)" $(srcdir)/runtests.sh
+# We try to run the scripts with POSIX mode on, in the hope that will
+# catch Bash-isms earlier even if we're running on GNU.  Of course, we
+# might lose in the future where POSIX diverges from old sh.
+
+check: all $(CHECK_PROGS)
+	POSIXLY_CORRECT=1 rsync_bin=`pwd`/rsync srcdir="$(srcdir)" $(srcdir)/runtests.sh
 
 # This does *not* depend on building or installing: you can use it to
 # check a version installed from a binary or some other source tree,
 # if you want.
 
-installcheck:
-	rsync_bin="$(bindir)/rsync" srcdir="$(srcdir)" $(srcdir)/runtests.sh
+installcheck: $(CHECK_PROGS)
+	POSIXLY_CORRECT=1 rsync_bin="$(bindir)/rsync" srcdir="$(srcdir)" $(srcdir)/runtests.sh